Shopping Cart: 0 Items
Your cart is empty.
MENU

Water for Injection

  • Water for Injection - Clinofar
    Water for Injection - Clinofar
    Sterile Water for Injection, USP is a sterile, nonpyrogenic preparation of water for injection, which contains no bacteriostat, antimicrobial agent or added buffer and is supplied only in single-dose containers to dilute or dissolve drugs for injection. The blow-fill-sealed twist-off top, plastic ampule is molded from a specially formulated polypropylene. For I.V. injection, add sufficient amount... Sterile Water for Injection, USP is a sterile, nonpyrogenic preparation of wate...
     $14.21$17.76 -20%

This preparation is designed solely for parenteral use only after addition of drugs that require dilution or must be dissolved in an aqueous vehicle prior to injection.

Water is an essential constituent of all body tissues and accounts for approximately 70% of total body weight. Average normal adult daily requirement ranges from two to three liters (1.0 to 1.5 liters each for insensible water loss by perspiration and urine production). The small volume of fluid provided by Sterile Water for Injection, USP when used only as a pharmaceutic aid for diluting or dissolving drugs for parenteral injection, is unlikely to exert a significant effect on fluid balance except possibly in newborns or very small infants.

This preparation is indicated only for diluting or dissolving drugs intended for parenteral injection, according to instructions of the manufacturer of the drug to be administered.

Do not use unless the solution is clear and seal intact. Do not reuse single-dose containers, discard unused portion.

Consult the manufacturer's instructions for choice of vehicle, appropriate dilution or volume for dissolving the drugs to be injected, including the route and rate of injection.

Inspect reconstituted (diluted or dissolved) drugs for clarity (if soluble) and freedom from unexpected precipitation or discoloration prior to administration.